
Packard Titan Pro TRCFD455 dual capacitor
45/5 MFD, 440/370 volt round dual run capacitor. The value that disappears first in July. Keep a stack, not a single spare.
As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure
Loading the stock list…
One Stop Shop Stock
Capacitors, contactors, relays, wire, terminals, and the meters that prove the circuit.
Category filters
18 parts in Electrical

45/5 MFD, 440/370 volt round dual run capacitor. The value that disappears first in July. Keep a stack, not a single spare.

40/5 MFD round dual run capacitor for the condensers that are not quite a 45/5. Label the bin so nobody grabs the wrong can.

35/5 MFD round dual run capacitor. Smaller tonnage condensers and a lot of package units still ask for this exact value.

5 MFD oval or round fan-motor run capacitor at 440 volts. Condenser fan motors eat these, and the symptoms look like a bad motor until you test it.

Two-pole definite purpose contactor, 30 amp, 24 volt coil. Pitted points on a July afternoon should be a bin pull, not a supply-house run.

Single-pole 40 amp contactor with a 24 volt coil for the furnaces and air handlers that switch only one leg.

Two-wire hard start kit for single-phase compressors that groan and trip on a hot start. Stock it before a customer asks you to keep resetting the breaker.

24 volt switching relay for blower and fan circuits. A seized relay is a no-cool call that is fixed from the electrical bin.

40 VA multi-mount transformer, primary 120/208/240 to a 24 volt secondary. Undersized transformers cook themselves the week a new thermostat goes in.

Stranded 12 gauge THHN for whip repairs, disconnects, and the condenser circuit you should not be splicing with whatever is on the truck.

Eighteen-gauge, eight-conductor thermostat cable. Pull eight even when the stat only needs five, so the next add-on is not another fishing job.

Lever connectors for control wiring and the occasional whip splice you can actually reopen. Faster than wire nuts when the panel is full.

A jar of winged wire connectors in the sizes control cabinets actually use. Replace the melted orange one instead of reusing it.

Clamp meter that reads the capacitor value in circuit and the amp draw on a compressor common. This is the meter that lives in the truck, not the drawer.

True-RMS meter for control voltage, continuity, and the flame-sensor microamp reading a clamp will not do well. Keep one as the bench meter.

Non-contact tester for a quick check before you pull a disconnect or open a cabinet. It is not a meter, and every helper should still have one.

Insulated female spades, rings, and butts from 22 to 10 AWG. Contactor coils and capacitor leads fail at the terminal more often than in the wire.

NEMA 3R pull-out disconnect, 60 amp, non-fusible. The rusted disconnect at the condenser is a stock part, not a special order.